Call Toll Free : 800-970-1128 Fax: 360-835-7188
Home | GIFTS | Crystals | Application Instructions

Application Instructions

MATERIAL
All Dinosaurs are printed on self-adhesive, peel and stick waterproof vinyl. The stickers are designed for indoor and outdoor use on any smooth, clean, dry surface.

ADHESIVE
The self adhesive vinyl can be removed. Adhesive will not remain on the wall when the vinyl is removed.

APPLYING VINYL
Adheres to almost any smooth surface; metal, wood, glass, cardboard, paper, plastic, etc. Also adheres to lightly textured walls (see below). Simply remove the backing and apply to a clean dry surface. The self adhesive cutouts are waterproof, but will be damaged by abrasion or solvents. They can be used in the shower or outdoors. They can be used on a vehicle, but there is no guarantee for this application. If being used on a vehicle, they should be coated with a clear, water based coating. Please do not place our product within reach of a young child�s crib or bed.

APPLICATION INSTRUCTIONS
Lay vinyl face down and pull the liner off part way; about 8 inches. Fold the liner back on itself so the exposed back of the vinyl can be applied to the wall. Remove entire backing on smaller designs. Be careful not to bend or kink the vinyl. Do not allow the adhesive on the back to contact any other area on the back of the vinyl! The design may stretch or tear if you try to remove the backing too quickly. After backing is removed, press exposed vinyl to surface. Slowly pull the backing off and push the design on the wall as you pull the backing. Finish by softly rubbing the entire sticker with a soft cloth, making sure to include all edges. If, after completion, you are unhappy with the positioning, simply remove and stick again. If the sticker does not stick well or curls at the edges, follow the instructions below. If there are air bubbles, take a pin and poke a hole through the bubble and press. If you find the sticker pulls off the paint, you can release the sticker by squirting lighter fluid on the wall above the sticker. The lighter fluid will run down the wall and soften the adhesive. The lighter fluid will evaporate off the wall in a few minutes. Once the sticker is off, lay it face down for a few minutes and let the lighter fluid evaporate. You can then re-apply the sticker.

TO APPLY TO ROUGH OR GLOSSY SURFACES
The sticker works best on flat walls with clean, dry flat paint. They will work on other surfaces with varying degrees of success. When you get your order, try a small sticker. If it doesn�t stick well, there is a product that can be used to increase the adhesion. The product creates a stronger bond. You can get it at �Staples� or other office supply stores. It is made by 3M and it is called �Super 77.� Put the sticker on the wall. Spray some adhesive into a paper cup. Using a small �� brush, lift the edge of the sticker off the wall and paint the adhesive on the back of the sticker. Push the edge back on the wall. The sticker will stick within a few minutes as the adhesive dries. Be careful not to get �Super 77� on the face of the sticker. Lighter fluid can be used to clean excess glue, but may damage the sticker. If the walls are very glossy, you can try using �Hi-Strength 90� by 3M.

TO CLEAN STICKERS
Use soapy water and a soft towel. Please do not use abrasives or harsh cleaners or solvents.

WARRANTY
We take pride in our products. In the event that a product is defective in material or workmanship, liability is limited to the replacement of the same product.

RETURNS
Returns are accepted within 30 days of purchase. Must be unused and in original saleable condition. Please call Customer service tel: 800-970-1128 or 360-835-2228.



Sign up now for specials deals and updates!

Application Instructions