Call Toll Free : 800-970-1128 Fax: 360-835-7188
Home | WALL STICKERS | DINOSAURS | Instruction Sheets for Installation of Dinosaur Wall Stickers

Instruction Sheets for Installation of Dinosaur Wall Stickers

MATERIAL
All Dinosaurs are printed on self-adhesive, peel and stick waterproof vinyl. The stickers are designed for indoor and outdoor use on any smooth, clean, dry surface.

ADHESIVE
The self-adhesive vinyl can be removed. Adhesive will not remain on the wall when the vinyl is removed.

APPLYING VINYL
Adheres to almost any smooth surface; metal, wood, glass, cardboard, paper, plastic, etc. Also adheres to lightly textured walls (see below). Simply remove the backing and apply to a clean dry surface. The self-adhesive cutouts are waterproof, but will be damaged by abrasion or solvents. They can be used in the shower or outdoors. They can be used on a vehicle, but there is no guarantee for this application. If being used on a vehicle, they should be coated with a clear, water based coating. Please do not place our Dinosaur Wall Stickers within reach of a young child crib or bed.

APPLICATION INSTRUCTIONS
Lay vinyl face down and pull the liner off part way; about 8 inches. Fold the liner back on itself so the exposed back of the vinyl can be applied to the wall. Remove entire backing on smaller designs. Be careful not to bend or kink the vinyl. Do not allow the adhesive on the back to contact any other area on the back of the vinyl! The design may stretch or tear if you try to remove the backing too quickly. After backing is removed, press exposed vinyl to surface. Slowly pull the backing off and push the design on the wall as you pull the backing. Finish by softly rubbing the entire sticker with a soft cloth, making sure to include all edges. If, after completion, you are unhappy with the positioning, simply remove and stick again. If there are air bubbles, take a pin and poke a hole through the bubble and press. If you find the sticker pulls off the paint, you can release the sticker by squirting lighter fluid on the wall above the sticker. The lighter fluid will run down the wall and soften the adhesive. The lighter fluid will evaporate off the wall in a few minutes. Once the sticker is off, lay it face down for a few minutes and let the lighter fluid evaporate. You can then re-apply the sticker.

TO CLEAN STICKERS
Use soapy water and a soft towel. Please do not use abrasives or harsh cleaners or solvents.

* Recommended Surfaces:
* Smooth Walls
* Painted Drywall
* Glass
* Metal
* Sanded Wood (without lacquer)
* Inside, temperature controlled environments

** NOT Recommended Surfaces:
* Freshly painted walls. Wait 30 days after painting before you put up your Dinosaur.
* Textured Walls
* Unpainted drywall
* Brick
* Cinder Block
* Porous, textured paneling
* Outside, non-temperature controlled environments


Sign up now for specials deals and updates!

Instruction Sheets for Installation of Dinosaur Wall Stickers